Sew a Heart-Shaped Potholder for the Cutest Kitchen Decor

heart-shaped potholder

This quick-and-easy potholder is awww-dorable, and it’ll look perfect in your kitchen come Valentine’s Day. An added bonus: it’s great for using fabric scraps!

Heart-Shaped Potholder

Level: Easy

What You Need

  • Free PDF pattern
  • Two colors of fabric
  • Insulating batting
  • Pins
  • Fabric marker
  • Thread
  • Iron
  • Point turner
  • Ruler
  • Scissors
  • Ribbon or twill tape (optional; for hanging)
  • Instructions

    1. Print and Cut the Pattern

    cut pieces

    Download and print the potholder template. Be sure to print it at 100% and not “scale to print” so it prints the correct size.

    Cut the template out and follow the instructions on each piece for cutting the fabric. You’ll have two full-sized fabric hearts (one for the front and back) and four smaller, half-hearts. You’ll also cut the batting to be a full-sized heart.

    2. Join the Halves

    pin pieces

    Place two half-hearts right sides together and pin along the straight line.Repeat for the other two half-hearts.

    sew pieces

    Sew the straight edges with a ¼ ” seam allowance. Press the fabric open on the right side.

    3. Press and Pin

    press seam

    Fold the fabric so the wrong side is facing up and the outer curves are aligned. Press the seam flat.

    trim bottom

    Pin along the seam and trim off the little point at the bottom that was created when folding the two pieces together.

    4. Topstitch

    top stitch

    Topstitch both pieces along the straight seam, ⅛” from the sewn edge. Press well.

    Pro Tip: Consider using a contrasting thread color for this step — the exposed stitching can be a nice detail.

    5. Join to the Front

    layer pieces

    Place one of the half-heart pieces on front heart piece, so the top and left edges line up. Pin along the curved edge, then pin the second piece to the top right of the heart.

    stitching heart potholder

    Stitch along the curve at a ⅛” seam allowance. This is essentially a baste stitch, but we used a regular stitch length. You can use whichever you like best.

    6. Add the Ribbon

    pin loop

    If you want to give your potholder a hanging loop, cut a piece of ribbon or twill tape in your desired length. Fold it in half and place it wherever you like, with the raw edges in line with the raw edge of the fabric. Stitch along the edge at ⅛” on top of the stitches from the previous step.

    7. Quilt

    mark quilting

    Quilt your potholder to join the pieces together. You can quilt in any way you like, from free-motion quilting to walking foot quilting. We chose to use a ruler and marked a 1″ square grid on the back heart piece.

    Pin the batting to the wrong side of the back heart piece. Pin baste so the layers don’t shift as you stitch.

    quilting

    Quilt through the fabric and the batting. If you have a walking foot for your machine, this is a great opportunity to use it to keep the layers moving in unison.

    Pro Tip: These layers are a bit thick, so turn up your stitch length. This will help you work smoothly through each layer.

    quilted

    Once you’ve finished quilting, press the back fabric. Be very careful not to touch the batting with the iron, as it will melt. If you have any excess batting hanging off the edges, trim it away first.

    8. Mark the Pivot Points

    mark pivots

    At the top V of the heart, mark an X on the wrong side of the fabric where the two seam allowances meet.

    mark pivots

    Mark an X at the bottom of the heart as well.

    9. Sew It Together

    pin

    Place the front and back pieces right sides together. Line up the edges and pin all the way around the heart. Measure a 3″ section to leave open.

    Pro Tip: Leave the gap on the bottom, about 1½” from the tip of the heart. This is the straightest section of the heart, so it’s the easiest to close up afterward.

    pivot

    Sew all the way around the heart with a ¼” seam allowance, pivoting at both the top and bottom of the heart and leaving the 3″ section you marked unsewn. Trim the seam allowance down to ⅛” around the entire heart (except the 3″ opening). Snip into the top V of the heart so it’ll lie flat.

    10. Turn It Out

    turn

    Turn the potholder right side out through the opening you left. Use a point turner to carefully poke out all the corners and curves. Finger press all the edges, then press with an iron.

    11. Finish It

    pin opening

    Fold the seam allowance back into the opening and press it flat. (This is much easier done with the whole ¼” seam allowance in tact, which is why we did not trim it.) Pin the opening closed.

    topstitch

    Topstitch around the entire heart at a ⅛” seam allowance. This will close the remaining hole.

    heart-shaped potholder

    Give the potholder a final press, then hang or use in your kitchen!

    Share tips, start a discussion or ask one of our experts or other students a question.

    Make a comment:
    characters remaining

    15 Responses to “Sew a Heart-Shaped Potholder for the Cutest Kitchen Decor”

    1. Diane

      Would love to learn more craft projects. Looks like a fun project and would be a wonderful gift. Thank you

    2. Tina

      Hi, I would like to make these lovely potholders but also have problems with the printing. Although I follow the instructions the pieces come out too large and the small piece is too large in relation to the bigger one. I have contacted customer services but haven't had a reply yet.

    3. Patricia

      The pattern for the heart is too large for the letter size paper, the curve of the heart gets cuts no matter how I have tried changing the print parameters. Could you redo that pattern in a size that will actually print out the entire heart shapes?

    4. Elizabeth

      Would love to make these

    5. LINDA ABRAMS

      where do I find the printable pattern pieces to cut the heart shape

    6. Yahooie

      This potholder is so adorable. Guess I'm making a few of these this fall for gifts for the coming season. The directions are very nicely done. I've sewed for years and as a technical writer/editor, I can say this was done well.

    7. Carol Callaghan

      where do i find the pattern please?

    8. Gwen Kaip

      No thanks

    9. ingpohl16390033

      Love this fabric - can you tell me where it is from?

    10. Lorraine Nielson

      Where do I find the PDF?